fan mountĪ series of fan mounts using generic 5015 or 5020 blower fan mounts optimized for each hotend is provided. NOTE: Whichever of these daughterboard mounts you use, the LED will no longer be positioned to shine below the nozzle unless you design and make your own modifications to address that. The first mount places the board too low for the LED to safely clear your models and bed clips. 3 versions are available: one to mount the PCB directly to the mount (on standoffs) and two others that allow/require you to use the plastic OEM mounting plate/cover to mount the board to the plate. A separate mount can be found in the daughterboard directory. The daughterboard needs to be mounted on its own mount as the stock mount interferes with the extruder. The disadvantage is that the stock hot end cover does not fit any longer (A series is planned which will work with the stock hot end cover, however the filament path will inevitably be slightly longer). There are a few gantry mounted direct drive setups available that try to avoid this pushing down on the strain gauge issue by installing a washer. Only the Hemera and alike designs achieve even shorter filament paths. Mounting the extruder this way ensures the shortest possible filament path which is exactly the aim of a direct drive setup. Only the upward movement to enable bed measurement is allowed. An added benefit is that the mount will prevent the strain gauge from vibrating as it blocks downward movement. The aim is to avoid the issue of the extruder pushing down on the strain gauge and causing variation in layer height in the typical gantry mounted direct drive setups. I link the relevant page in every subdirectory.Ī collection of hot end and extruder combinations for the Creality CR-6 SE and CR-6 MAX is provided in this repo.įor ease of use the structure has been changed with every possible hotend in a directory followed by directories with the different extruders.Īll extruder / hot-end combinations are mounted directly onto the strain gauge without any connection to the carriage. Creality CR-6 SE & MAX extruder and hotend collection mounting directly to the strain gaugeĬreality CR-6 SE & MAX extruder and hotend collection mounting directly to the strain gauge I am in the process of moving this repo over to the repository of prints, for the latest updates please check the collection page.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |